GE Druck DPI 620-IS - Set the Automation Options (Source)

Issue 1
2-16 Prepare the instrument K0460 - [EN] English
Scaling:
2.9.2 Set the Automation options (source )
Note: Section 2.7 (Display operation) shows how to set and
change the values on the display.
Nudge
Span Check
Set a scale for
Point 1 and Point 2.
Set On or Off
Set a label name.
Previous: Back one display.
Home: Back to start.
1
2
3
1
TAP
Description
Process: Nudge; Values to set: Step Size.
Use these buttons to increase or decrease the output
value. Increments = Step size.
Use this button (set-point) to set the output value.
1
TAP
Description
Process: Span Check; Values to set: Low, High, Dwell
Use these buttons to change the value manually from
High to Low.
Use the start and stop buttons to change the value
automatically from High to Low.
Dwell sets the period between each change. The cycle
repeats automatically.