Issue 1
2-4 Prepare the instrument K0460 - [EN] English
2.5.5 Operating time
These are typical operating times for a new, fully-charged
Ni-MH battery pack with these settings:
• Backlight Intensity set to 80% (Default: 80%).
• Backlight Timeout set to 2 hours (Default: 2 minutes).
Power save options To get the best battery duration, set a low value for the
Backlight Intensity (40%) and a short Timeout; see
Section 2.8.1 (Procedure to set the basic operations:).
2.6 Power on or off
To set the instrument power on, press and hold this button
down until the display comes on (≈ 2 seconds). During the
power on sequence, the instrument shows a timer and then
shows the applicable data.
To set the instrument power off, press and hold this button.
When the power is off, the last set of configuration options
stays in memory.
2.7 Display operation
This instrument has a touch-screen. To make a selection,
lightly tap on the applicable display area (window, button,
option) with a finger.
Caution: To prevent damage to the display, do not use
sharp objects on the touch-screen.
The number of windows shown on the display is set by the
number of task selections and external modules enabled
(maximum: 6); see Section 2.8.3 (Procedures to make Task
selections).
Operation Battery duration
Continuous operation (measure) > 10 hours
Continuous operation (measure and
source with loop power on)
> 6 hours
To Next Page
Loading...
