GE Druck DPI 620-IS - 2.9 Measure and source operations; 2.9.1 Set the Process options (measure); 2.9.2 Set the Automation options (source)

[EN] English - K0460 Prepare the instrument 2-13
Issue 1
2.9 Measure and
source operations
After setting the measure and source functions required on the
display (see Section 2.8.3), these procedures can be set:
• If necessary, change the Process for the CH1 and/or CH2
measure functions (item ) including:
Tar e, Alarm, Filter, Flow, Scaling; see Section 2.9.1.
For more optional Settings for the TC, Frequency, and RTD
functions; see Chapter 3.
• If necessary, change the Automation options for the CH1
and/or CH2 source functions (item ) including:
Nudge, Span Check, Percent Step, Defined Step, Ramp;
see Section 2.9.2.
For more optional Source Settings for the TC, Frequency,
and RTD functions; see Chapter 3.
For other Settings for Observed functions; see
Section 2.9.3.
• If necessary, change the Settings for the pressure function
(item ):
a. Process (Tare, Alarm, Filter, Flow, Scaling); see
Section 2.9.1.
b. Leak Test (Only when the function is set-up with this
Utility - Section 2.8.6); for operation, see Chapter 4.
c. Zero; see Chapter 4.
• If necessary, change the Configuration (item ) including:
Data Logging (Chapter 6), Documenting (Chapter 7), and
Advanced options (Section 2.10).
• When all the software selections are complete, make the
applicable connections (electrical and/or pressure).
Examples:
a. Electrical operations (Chapter 3).
b. Pressure operations with the MC 620-IS module carrier
(Chapter 4).
c. Pressure operations with a PV 62x-IS pressure station
(refer to the user manual - K0462).
1
A
TAP
A
1
B
TAP
B
1
C
C
D
2
1
D