Issue 1
2-10 Prepare the instrument K0460 - [EN] English
c. * Pressure function (P1): for the PV 62x-IS pressure
stations, refer to user manual - K0462; for the MC 620-IS
module carrier, see Chapter 4.
d. * Pressure function (P2): the MC 620-IS module carrier
can use P1 and/or P2; see Chapter 4.
e. HART function: HART device communications; see
Chapter 8.
• If applicable, change the Units for the function: item ;
see Section 2.8.5.
• If applicable, set a Utility for the function: item
a. Max/Min/Avg; see Section 2.8.6.
b. Switch Test: CH1, P1, P2 and IDOS functions use the
CH2 switch connections; CH2 functions use the CH1
switch connections. See Chapter 3.
c. Leak Test (Pressure options only); see Chapter 4.
Note: Making the connections for a switch on CH1 or CH2
means another function cannot be set on that channel.
Note: * Observed (Only
available as a source
option). Use this option to
make a manual record of
the readings on another
instrument; see
Section 2.9.3.
To Next Page
Loading...
