Preventive maintenance
2026419-033E CIC Pro™ 10-5
NOTE
The GE service personnel will not be carrying these items.
Sodium hypochlorite (5.2% household bleach) minimum 1:500 dilution
(minimum 100 ppm free chlorine) and a maximum 1:10 dilution.
Any sodium hypochlorite wipe product that meets the above guidelines can
be used.
3. Wipe off cleaning solutions with a clean, lightly moistened cloth. Wring excess
disinfectant from wipe before using.
4. Dry thoroughly with a dry lint-free cloth and let air dry for at least 30 minutes.
NOTE
Drying times may vary based on the environmental conditions.
5. Take care not to let fluid pool around connection pins. If this should happen, blot
dry with a soft lint-free cloth.
6. Do not use excessive drying techniques, such as oven, forced heat, or sun drying.
Internal components
CIC Pro center
WARNING
In order to remove power from the CIC Pro center, disconnect the
power cord from the wall outlet. The power switch on the back panel
of the processor box does not disconnect the CIC Pro center from
AC power.
Additionally, wait 40 seconds after disconnecting the CIC Pro
center power cord from the wall outlet. The unit remains energized
for a period of time after shutdown.
The fan, fan intakes, and internal components require cleaning to remove
accumulated dust.
1. Perform safe shutdown of the CIC Pro center on page 8-31.
2. Disconnect all peripheral devices from the CIC Pro center.
3. Turn off and unplug all equipment.
4. Remove the CIC Pro center cover.
5. Clean as necessary.
6. Replace the CIC Pro center cover.
To Next Page
Loading...
Need help?
General
