Introduction
2026419-033E CIC Pro™ 1-11
Service requirements
Follow the service requirements listed below, and in the Preventive maintenance
chapter of this manual.
Refer equipment servicing to GE authorized service personnel only.
Any unauthorized attempt to repair equipment under warranty voids that
warranty.
It is the user’s responsibility to report the need for service to GE or to one of their
authorized agents.
This symbol indicates that the waste of electrical and electronic equipment must not be disposed as unsorted
municipal waste and must be collected separately. Please contact the manufacturer or other authorized disposal
company to decommission your equipment.
European authorized representative.
Manufacturer name and address.
Equipotential stud. A ground wire from another device can be tied here to ensure the devices share a common
reference point.
NOTE
The following symbols (required by China law only) are representative of what you may see on your equipment.
The number in the symbol indicates the EFUP period in years, as explained below. Check the symbol on your
equipment for its EFUP period.
This symbol indicates the product contains hazardous materials in excess of the limits established by the Chinese
standard SJ/T11363-2006 Requirements for Concentration Limits for Certain Hazardous Substances in Electronic
Information Products. The number in the symbol is the Environment-friendly User Period (EFUP), which indicates the
period during which the toxic or hazardous substances or elements contained in electronic information products will
not leak or mutate under normal operating conditions so that the use of such electronic information products will not
result in any severe environmental pollution, any bodily injury or damage to any assets. The unit of the period is
“Year”.
In order to maintain the declared EFUP, the product shall be operated normally according to the instructions and
environmental conditions as defined in the product manual, and periodic maintenance schedules specified in Product
Maintenance Procedures shall be followed strictly.
Consumables or certain parts may have their own label with an EFUP value less than the product. Periodic
replacement of those consumables or parts to maintain the declared EFUP shall be done in accordance with the
Product Maintenance Procedures. This product must not be disposed of as unsorted municipal waste, and must be
collected separately and handled properly after decommissioning.
This symbol indicates that this electronic information product does not contain any toxic or hazardous substance or
elements above the maximum concentration value established by the Chinese standard SJ/T11363-2006, and can be
recycled after being discarded, and should not be casually discarded.
Symbol Description
To Next Page
Loading...
Need help?
General
