GE MP100 Series User Manual

Installation
2026419-033E CIC Pro™ 5-9
WARNING
Only external devices specifically designed to be connected to the
CIC Pro center, or approved by GE for use with the CIC Pro center,
should be connected, as specified in this manual or as otherwise
specified by the manufacturer.
A shock hazard may exist if external devices are connected
differently from described in this manual, or as directed by the
manufacturer.
External equipment must be connected to the CIC Pro center only
by qualified biomedical engineering personnel.
CIC Pro center v5.1.x does not support the use of a KV/KVM
switch. Do not use a KVM switch with mixed versions of CIC Pro
center (CIC Pro center v5.1.x and 4.1.1 or 4.0.x).
WARNING
SITE REQUIREMENTS — Do not route cables in a way that they
may present a stumbling hazard. For devices installed above the
user, adequate precautions must be taken to prevent them from
dropping on the user.
WARNING
ACCIDENTAL SPILLS — To avoid electric shock or device
malfunction, liquids must not be allowed to enter the device. If
liquids have entered a device, take it out of service and have it
checked by a service technician before it is used again.
WARNING
BEFORE USE — Before putting the system into operation, visually
inspect all connecting cables for signs of damage. Damaged cables
and connectors must be replaced immediately.
Before using the system, the operator must verify that it is in correct
working order and operating condition.
Periodically, and whenever the integrity of the product is in doubt,
test all functions.

GE MP100 Series Specifications

General

Brand	GE
Model	MP100 Series
Category	Medical Equipment
Language	English