140 GE INFORMATION D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
APPENDIX F: FREQUENTLY ASKED QUESTIONS
A: Method 2: To view the identity of the D20E IO Module currently being configured:
1. Open a Web browser.
2. Type in the command: <ip address>/dapinfo.
Result: The following device information appears:
Substation Name: You can manually modify a Substation Name from the
General settings.
DAP Firmware Version:
Softkey: License key:
License Expiry Date:
Version (license):
Enabled DAP Functions:
Enabled Protocols:
Q: How do you configure a Counter?
A: Refer to section: Configure counter points on page 60 for this configuration
procedure.
Q: How do you set the Analog Input to match the legacy hardware (signed 16 bit
integer)?
A: Refer to section: Set Analog Input for D20E IO Calculator function (example) on page
68 for this configuration procedure.
To operate a R/L (raise/lower) Digital Output point:
Q: How do you operate a R/L (raise/lower) Digital Output point)?
A: Refer to section: Operate a raise/lower DO point on page 107 for this configuration
procedure.
Q: How do you operate control output points?
A: Refer to section: Operation of control output points on page 73 for this procedure.
Q: How do you access the system status information?
A: Refer to section: Check the D20E system status on page 73 for this procedure.
Q: How do you access the Event Log?
A: Refer to section: Access the Event Log on page 73 for this procedure.
Q: How do you test previously configured input/output points using DAPserver
Studio?
A: Refer to section: Test your field I/O on page 102 for this procedure.
Q: How do you setup Time Synchronization?
A: Use the Time Sync window in DAPserver Studio to enable NTP Client. Also, note that
NTP should be used and DO NOT use both DNP and NTP simultaneously.
Refer to section: Configure NTP time sync on page 50 for this procedure.
To Next Page
Loading...
Need help?
General
