GE Sievers 900 Series - Reactivating Inactivated User Accounts; Archiving User Accounts

GE Analytical Instruments ©2009 131 of 236 DLM 90488-01 Rev. A
7. Verify the new Password and press Enter.
8. Press the Menu button to return to the DataGuard screen.
Reactivating Inactivated User Accounts
After five unsuccessful login attempts, a User ID is suspended and set to Inactive. An administrator
must reactivate the User ID before the user can log in to the system. To reactivate a User ID, follow
these steps:
1. Log in to the Analyzer with the administrator-level User ID and Password.
2. Select the DataGuard tab.
3. Press the Edit User button.
4. Select the User ID from the list using the scroll buttons and then press OK.
5. Press the User Status button and select Active.
6. If the user has forgotten the Password, you can assign a new Password now. Press the
Password button, specify and confirm the new Password, and press Enter.
7. Press the Menu button to save and return to the DataGuard screen.
Archiving User Accounts
If you want to remove User IDs from the user list, you must first set the unwanted User IDs to
Inactive and then archive your unused user settings as follows:
1. Log in to the Analyzer with an administrator-level User ID and Password.
2. Select the DataGuard tab.
3. Press the Edit User button.
4. Select a User ID from the list using the scroll buttons and then press OK.
5. Press the User Status button and select Inactive.
6. Press the Menu button to save the change and return to the DataGuard screen.
Note: Require the user to change the Password upon log in so that it will be easy to
remember and unknown to the administrator.