GE Analytical Instruments ©2009 80 of 236 DLM 90488-01 Rev. A
Enabling Password Protection
If you will be using basic Password protection rather than DataGuard, activate the password now
by following the steps below. Note that if DataGuard will be activated, there is no need to
additionally activate the Password feature and you can proceed to the next section.
1. Select the DataGuard tab.
2. Press the Enable Password button.
Once Password protection is enabled, you will immediately be required to log in to the Analyzer with
the default Administrator User ID and Password:
User ID: ADMIN
Password: GEAI
For security purposes, change the default password. After you have logged in using the default
password, follow these steps:
1. Select the DataGuard tab.
2. Press the Change Password button.
3. Enter the old password (GEAI) and press Enter.
4. Enter the new password and press Enter.
5. Verify the new password and press Enter.
6. Record the new password in a secure location. All users will be required to enter this log in
information to access the Analyzer’s menus.
Enabling DataGuard
If you are enabling DataGuard, follow these steps:
1. Insert the USB flash drive containing the DataGuard activation into the Analyzer’s USB
port.
2. Press the Menu button, select the Maintenance tab, and press the Advanced button.
3. Press the Activate Options button.
4. Press the OK button and wait for the Analyzer to detect the USB flash drive.
5. Press the Activate button to enable DataGuard.
To Next Page
Loading...
