GE Sievers 900 Series - Wiring the 4-20 Ma Connection

GE Analytical Instruments ©2009 70 of 236 DLM 90488-01 Rev. A
Wiring the 4-20 mA Connection
The data from the Analyzer may be recorded using the 4-20 mA output located on TB3. The analog
output is calibrated at the factory prior to shipping. Wiring connections are shown in Figure 6.
Table 3: Serial and 4-20 mA Inputs/Outputs (TB3)
Pin Number (from left) Output
12 4-20 mA (- Output)
11 4-20 mA (+ Output)
10 Not used
9Not used
8Reserved
7Reserved
6Reserved
5Not used
4 Serial (In)
3 Serial (Out)
2 Serial (ground)
1Not used