GE Analytical Instruments ©2009 92 of 236 DLM 90488-01 Rev. A
• Setup — Set the Analyzer mode and change parameters such as reagent flow rates and, in
Grab mode, the number of repetitions and the number of rejects.
• Data — Display and export historical data stored in RAM.
• I/O — Configure the input and output of data from the Analyzer.
• Maintenance — Display information about the Analyzer’s consumables levels, system
information, and error messages. Also perform calibration and system suitability
operations.
• DataGuard — Configure the access settings and user passwords for your Analyzer.
From any tab under the Menu screen, you can press the Start Analysis button to initiate TOC
measurements.
Figure 12: The Setup Tab
Setup
Options on the Setup tab let you specify preferences and basic operation settings for the Analyzer
configuration. If the sample conditions for your application remain relatively constant, you should
seldom need to configure the settings here, especially if you use the Autoreagent flow rate setting.
Main
Configure Mode
Start Analysis Logout
Setup
DataGuard
I/OData
Maintenance
Grab
On-Line
Enable Turbo
Setup 4 Mar 2004 08:20
To Next Page
Loading...
