GE Analytical Instruments ©2009 174 of 236 DLM 90488-01 Rev. A
7. Fill the water bottle from the Analyzer accessory kit with DI water and use the nozzle on the
water bottle to fill the DI water reservoir. Fill the reservoir until the water level reaches the
fill line.
8. Replace the inlet cover by gently pushing it back into place on the reservoir.
9. If you need to replace other consumables, follow the procedures listed in the appropriate
sections of this chapter. Otherwise, close and latch the Analyzer door.
Figure 31: Filling the DI Water Reservoir
Warning
Do not over-fill the DI water reservoir.
To Next Page
Loading...
