page | 161
Using the GAVA with a KNX Automation System
Appendix
3. Get the gateway information from the installer / electrician. In most cases,
a KNX IP-Router device will be used. However, GAVA can also use a KNX Tunnel
device as the gateway.
4. Have the installer / electrician provide the physical address of the gateway.
This address is a typical bus address (e.g. 0.0.254). The IP address of the
gateway can also be entered in the GAVA Wizard.
5. Upload the .esf le to the GAVA. See the sample .esf le on the next page.
KNX IP-Router
To Next Page
Loading...