GEFRAN-SIEI ARTDrive Vector V2 Series - Page 157

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
ARTDrive V2 series - Instruction Manual Chapter 6 Parameter • 157


 INTERFACE / Digital outputs
The blocks of the digital outputs allow to turn an internal signal into a signal available on
the terminal strip.
F
.
.
.
.
DO 0
DO 1 src
Spd is zero dly
DO 0 inversion
DO 2 src
NULL
DO 3 src
NULL
DO 0X src
NULL
DO 1X src
NULL
DO 2X src
NULL
DO 3X src
NULL
DO 4X src
NULL
DO 5X src
NULL
DO 6X src
NULL
DO 7X src
NULL
DO 0 src
Drive OK
DO 1 inversion
Not inverted
DO 2 inversion
Not inverted
DO 3 inversion
Not inverted
DO 0X inversion
Not inverted
DO 1X inversion
Not inverted
DO 2X inversion
Not inverted
DO 3X inversion
Not inverted
DO 4
X inversion
Not inverted
DO 5X inversion
Not inverted
DO 6X inversion
Not inverted
DO 7X inversion
Not inverted
Exp dig out en
Disabled
C19 INTERFACE / DO Cfg
C19.00 DO 0 src N/A RWS Ipa9097 PList 1 PIN V-F-S-B Easy 4065
Ipa 9097 - [8] Drive OK = Default
It allows to connect the selected signal to the Digital output 0. Refer to signals of Pick
List 1 below, and it can also defines the conditions that the relay contacts will close.
For example:
Drive OK The contact closes when the drive is powered up with no failure alarms.
Drive Ready The contact closes when the following conditions are fulfilled:
- The drive is powered up