GEFRAN-SIEI ARTDrive Vector V2 Series - Drive Menu - Main Level

84 • Chapter 5 Quick Start Up Guide ARTDrive V2 series - Instruction Manual
5.4.6 Drive Menu - Main Level
The menu visualisation is available in two mode set by B05.00 - Access level
parameter (STARTUP menu):
- Easy (default) only main parameters are shown
- Full include all parameters
Drive display variables
Initial commissioning configurations
Ramp setpoint, Ramp, Multipspeed, Jog, Motopot configurations
Speed setpoint & speed configurations
Torque current limit & torque functions
Flux configurations
DC braking & power loss functions
Alarm configurations
Serial link, communication cards & ISBus configurations
APC 100 card configurations
PID control configurations
Signal compare blocks & Playground PAD configurations
Service purpose menu with password
Regulator gains & control parameters
Commands and configurationsInput / Output
R: S:
DISPLAY A
R: S:
STARTUP B
R: S:
INTERFACE C
R: S:
REF & RAMP D
R: S:
SPEED REG F
R: S:
TORQUE G
R: S:
FLUX H
R: S:
FUNCTION I
R: S:
ALARM CFG L
R: S:
COM M
R: S:
APC CARD N
R: S:
APPL CFG O
R: S:
CUSTOM P
R: S:
R: S:
REG PARAM E
= Menu not available in Easy Access Level
SERVICE Q