ARTDrive V2 series - Instruction Manual Chapter 7 Appendix • 321
Figure 7.2.4: Flux Reference (CH1) and Magn Current Reference, with Overshoots, (CH2) Displaying
7.3 IGBT Voltage Output Distortion
The procedure shows an example to compensate the output voltage
distortion due to IGBT voltage drop and its switching characteristics.
Use a 3 channel digital scope + 1 current probe.
In the INTERFACE / An Out 1 menu, program the Analog output 1:
- C08.00 - AO 1 src connected to Norm speed variable
On the 21-22 drive terminals (Analog output 1), place channel 1 of the
digital scope to display the motor speed, (see chapter 4.3).
- Connect the current probe on channel C of the digital scope on one of
the motor wires to display the motor current (It's possible to use a
differential probe on XY5/XY4 regulation board test points instead of a
current probe on the output phases).
- Run the motor at 300 rpm.
Go to menu: REG PARAM / DeadTime
Adjust: E04.01 - Dead time slope parameter to match the figure 7.3.1.
To Next Page
Loading...