ARTDrive V2 series - Instruction Manual Chapter 2 Inspection Procedure,... • 17
specifications given by the manufacturer losses (bearings, unbalance etc.). This
also applies to temperature specifications for continuous operation under 20 Hz
(poor motor ventilation, not applicable to motors with external ventilation).
2.1.3 Nameplate
Check that all the data stated in the nameplate enclosed to the inverter correspond
to what has been ordered.
Figure 2.1.3.1: Identification Nameplate
Type : AVy 2003 -KBX-5 Inverter Drive S/N 02135387
Inp: 575 Vac 50/60Hz 3Ph Zmin=1%
4.5A@575Vac With Line Choke
Out : 0-575Vac 400Hz 3Ph 3Hp @ 575Vac
4.5A@575V Cont. Serv.
4.1A@575V Ovld. 150% 60s
LISTED
INDUSTRIAL CONTROL EQUIPMENT
Type: Inverter model S/N: Serial number
Inp: Power supply voltage - AC Input current -
Out: Output voltage - Output current - Output frequency
NOTE! CSA approval for AVy-...-5 series only !
Figure 2.1.3.2: Firmware & Card Revision Level Nameplate
Firmware HW release S/N 0062330 Prod.
Release D F P R S BU SW. CFG CONF
2.200 0.A 0.A 0.A 1.000 D1
Figure 2.1.3.3: Nameplates Position
To Next Page
Loading...