GEFRAN-SIEI ARTDrive Vector V2 Series - Internal Fuses

60 • Chapter 4 Wiring Procedure ARTDrive V2 series - Instruction Manual
4.6.3 Internal Fuses
Table 4.6.3.1: Internal Fuses
Drive type Designation Protection of Fuse (source) Fitted on:
4220 to 81600 F1 +24V
2Afast5x20mm(Bussmann:
SF523220 or Schurter: FSF0034.1519
or Littlefuse: 217002)
Power card PV33-4-D and higher
Power card PV33-5-B and higher
1007 to 81600 F1 +24V Resettable fuse Regulation card RV33-1 rev.C and higher
7900 to 71320 F3
Fans
transformer
2.5A 6.3x32
(Bussmann: MDL 2.5, Gould Shawmut:
GDL1-1/2, Siba: 70 059 76.2,5 ,
Schurter: 0034.5233)
Bottom cover (power terminals side)
4025 to 8200 F1 +24V
2Afast5x20mm(Bussmann:
SF523220 or Schurter: FSF0034.1519
or Littlefuse: 217002)
Power card PV33-4N-A and higher
Power card PV33-5N-A and higher
2002 to 8200
F1 +24V Resettable fuse Regulation card RV33-1 rev.C and higher
7125 to 8200 F3
Fans
transformer
2.5A 6.3x32
(Bussmann: MDL 2.5, Gould Shawmut:
GDL1-1/2, Siba: 70 059 76.2,5 ,
Schurter: 0034.5233)
Bottom cover (power terminals side)
avy4145
AVy… -5 (575Vac):
AVy…-4 (230…480Vac):
4.7 Chokes / Filters
NOTES! A three-phase inductance should be connected on the AC Input side in order to
limit the input RMS current of AVy series Drives. The required inductance can
be provided by an AC Input choke or an AC Input transformer.
NOTES! For the use of output sinusoidal filters, please contact the nearest GEFRAN-
SIEI office.
Figure 5.7.1: Input / output chokes dimensions