ARTDrive V2 series - Instruction Manual Chapter 6 Function Description • 99
6.1.3 Signal Normalization
This paragraph describes the relationship between the physical units (rpm,
Nm, A etc) and the Drive internal values. The different values which can be
read via process channels are stated through an internal value (Count value)
and the corresponding physical unit or parameter containing the reference
value (Parameter name or Physical unit value). Sometimes the paragraph
makes reference to tables listed in the following pages.
The conversion type, always linear, is stated for an internal use.
The code N/A (Not allowed) refers to a one to one conversion.
Ipa = Parameter number
Parameter Name Ipa Normalized Normalized Physical value
NULL 4000 N/A
ONE 4001 N/A
Output volt 3060 16384
Table2 last column
Output curr 3070 16384
Table1 last column
Output freq 3080 16384
Table4 last column
DCLink volt 3100 16384
500V
Magnetiz curr 3110 16384
Table1 last column
Torque curr 3120 16384
Table1 last column
MagnCurr ref 3130 16384
Table1 last column
TrqCurr ref 3140 16384
Table1 last column
Curr phase U 3150 16384
Table1 last column
Curr phase V 3160 16384
Table1 last column
Curr phase W 3170 16384
Table1 last column
Flux ref 3180 16384
2Wb for 575V, 1Wb for 230-460
Flux 3190 16384
2Wb for 575V, 1Wb for 230-460
Ramp ref 3200 16384
Full scale speed
Speed ref 3210 16384
Full scale speed
Speed 3220 16384
Table3 last column
Actual Speed 3221 16384
Full scale speed
Fault Pin 9098 N/A
Norm Std enc spd 3222 16384
Full scale speed
Exp enc spd 3223 16384
Full scale speed
DrvOL accum % 1540 16384
100%
MotOL accum % 1670 16384
100%
BU OL accum % 1781 16384
100%
Drive ready 161 N/A
EnableSM mon 162 N/A
Start SM mon 163 N/A
FStop SM mon 164 N/A
ALM Sequencer 9096 N/A
Drive OK 9097 N/A
Jog state 8013 N/A
Gen output 2760 N/A
AI 1 output 5009 16384
10V or 20mA
AI 2 output 5029 16384
10V or 20mA
AI 3 output 5049 16384
10V or 20mA
AI 1X output 5067 16384
10V or 20mA
AI 2X output 5087 16384
10V or 20mA
tab613-1
To Next Page
Loading...