ARTDrive V2 series - Instruction Manual Chapter 6 Function Description • 93
Chapter 6 - Parameter Description
6.1 General Considerations
The menu visualization is available in two mode set by Access level
parameter (STARTUP menu):
- Easy (default) only main parameters are shown
- Full include all parameters (Easy + Full)
See Level column on chapter X, Parameters:
The drive control diagram is made of functional Blocks each representing a
part of the total function. For example speed regulator, ramp etc., each
containing some Variables, the gains, the ramp times, the limits etc. The
input and / or output of Blocks are interconnected to make the complete
system function. Such interconnections are called SIGNALS.
The setting of the Drive parameters/variables can be performed via the
keypad or a PC Configurator.
The parameter functions is the following:
src (Source)
These are parameters that select where an input comes from.
The selections are from a pick-list.
The source is aimed at controlling (or enabling) the Block inputs.
cfg (Configuration)
These are parameters that define how the function or parameter acts.
For example: Ramp times, internal references adjustments.
mon (Monitor)
These parameters are variables. They are read only, and show the
value or state of a signal.
The three above elements are inside a menu, as needed by each single
Block.
Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
A08.00 Speed ref [rpm] R 0.00 0.00/0.00 PV V-F-S Easy 3210
Drive speed reference
A09.00 Enable SM mon N/A R 0 0/1 DV V-F-S Full 162
It shows the drive Enable state
0 OFF
1 ON
To Next Page
Loading...