42 • Chapter 4 Wiring Procedure ARTDrive V2 series - Instruction Manual
Figure 4.1.2: Removing the Covers for sizes 4220...81600 (230...480Vac) and 4025...8200
(575Vac)
Sizes 4220...81600 (230...480Vac) and 4025...8200 (575Vac)
The terminal cover of the device must be removed in order to fit the electrical
connections: unscrews the two screws (2) and remove the cover (1)
The top cover must be removed in order to mount the option card and change
the internal jumper settings: unscrew the two screws (3) and remove the top
cover by lifting it as indicated on figure (4)
In order to avoid damages to the device, it is not permissable to transport it by
griping its cards!
4.2 Power Section
Please note that a wrong connection on motor phases can cause the motor to
move without control and can destroy the drive.
Please check that motor phases are connected in the right sequence before
enabling the drive.
To Next Page
Loading...