ARTDrive V2 series - Instruction Manual Chapter 4 Wiring Procedure • 53
A connection point to point can be done using “PCI” option interface , without
jumper setting.
For multidrop connection (two or more drives) use an external power supply is
necessary (pin 5 / 0V and pin 9 / +5V). Pins 6 and 8 are reserved for use with the
“service” interface card.
When connecting the serial interface ensure that:
- only shielded cables are used
- power cables and control cables for contactors/relays are routed separately
4.4.2 RS 485 Serial Interface Connector Description
Table 4.4.2.1: Assignment of the Plug XS Connector for the RS 485 Serial Interface
Designation Function I/O Elec. Interface
PIN 1 Internal use – –
PIN 2 Internal use – –
PIN 3 RxA/TxA I/O RS485
PIN 4 Internal use – –
PIN 5 0V (Ground for 5 V) – Power supply
PIN 6 Internal use – –
PIN 7 RxB/TxB I/O RS 485
PIN 8 Internal use – –
PIN 9 +5 V – Power supply
I = Input O = Output
ai4110
To Next Page
Loading...