GEFRAN-SIEI ARTDrive Vector V2 Series - Chapter 4 - Wiring Procedure; Accessing the Connectors; Removing the Covers

ARTDrive V2 series - Instruction Manual Chapter 4 Wiring Procedure • 41
Chapter 4 - Wiring Procedure
4.1 Accessing the Connectors
4.1.1 Removing the Covers
N
OTE! Observe the safety instructions and warnings given in this manual. The devices
can be opened without the use of force. Only use the tools specified.
Figure 4.1.1: Removing the Coversfrom 1007 to 3150 (230...480Vac) and 2002 to 3020
(575Vac)
2
1
3
2
No. 2for
3110...3150 and
3007...3020 sizes
Sizes 1007...2075 (230...480Vac) and 2002...2005 (575Vac)
The terminal cover and cable entry plate of the device must be removed in order
to fit the electrical connections:
- unscrew the screw (1), remove the cover of devices (2) by pressing on both
sides as shown on the above figure (3).
- unscrew the two screws (4) to remove the cable entry plate.
The top cover must be removed in order to mount the option card and change
the internal jumper settings:
- remove the keypad and disconnect the connector (5)
- lift the top cover on the bottom side (over the connector level) and then
push it to the top (6).
Sizes 3110...3150 (230...480Vac) and 3007...3020 (575Vac)
The terminal cover and cable entry plate of the device must be removed in order
to fit the electrical connections:
- unscrew the two screw (1) and remove the cover of devices
- unscrew the two screws (4) to remove the cable entry plate.
The top cover must be removed in order to mount the option card and change
the internal jumper settings:
- remove the keypad and disconnect the connector (5)
- lift the top cover on the bottom side (over the connector level) and then
push it to the top (6).