ARTDrive V2 series - Instruction Manual Chapter 8 Appendix • 347
8.2 List of Error Alarm Events
Entering bad data or conflicting data into the drive configuration will cause
user errors to be displayed.
These type of errors can be:
- Configuration errors
- Data Base errors (DB errors)
Refer to the following paragraphs for descriptions.
8.2.1 Configuration Errors
Configuration errors can occur by entering incompatible or invalid parameter
data.
The error indicates which parameters are causing the problem in the Setup
Mode:
- Motor data
- Drive data
- Start Up parameter
The drive reports configuration error by the following example description:
Calc error: 606
Param: 0000
The “Calc error” number denotes the cause of invalid calculation. The error
number reported by this process is set in part of the reply signal.
The Calc error numbers is composed as follows:
Calc error = Offset + Error code
The Offset denotes the type error:
0 for specific errors
100 for errors originated by the database calculation (see DB error paragraph)
500 for errors due to floating point calculation (exception, divide by zero
etc..)
600 for errors originated by the configuration calculations (range and so on).
The Error code denotes the origin cause of the error (for the Error code values
lists see below).
For example, Calc error number 606 is a configuration error (600) caused by
speed base value (6) out of range.
The “Param” number is not meaningful.
Error code values lists
Error code values for Offset 0 :
0 no error
1 signal not managed in current configurator state
2 cannot stop regulation
3 recipe export error
4 recipe import error
5 error while loading selftune data
6 error while loading motor data
To Next Page
Loading...