348 • Chapter 8 Appendix ARTDrive V2 series - Instruction Manual
7 reserved
8 error while loading customer specific data
9 error while loading drive size data
10 error while writing file size.ini
11 error while apply database. The operation is refused because errors arised during group
calculation. To reset the errors it is necessary re-enter the data, and confirm correctness
12 error while saving too changes
Error code values for Offset 100:
See DB errors, section 8.2.2.
Error code values for Offset 500 (500 + error code):
3 Integer overflow
4 Floating overflow
5 Floating underflow
7 Divide by zero
9 Undefined float
10 Conversion error
11 Floating point stack underflow
12 Floating point stack overflow
Error code values for Offset 600 (600 + error code):
0 no error
1 switching freq. error
2 mains voltage error
3 ambient temperature error
4 regulation mode error
5 take selection error
6 base speed error
7 drive size error
Drive size setting
NOTE! If the User changes the Drive size, the drive will display:
Drv size: new size - old size
For example: Drive size: 0 - 1
For the drive size number the table below:
400/460Vac Series 575Vac Series
[0] 0.75kW-0.75Hp [2] 575V - 2.0Hp
[1] 1.5kW - 1.5Hp [3] 575V - 3.0Hp
[2] 2.2kW - 2.0Hp [4] 575V - 5.0Hp
[3] 3.0kW - 3.0Hp [5] 575V - 7.5Hp
[4] 4.0kW - 5.0Hp [6] 575V - 10Hp
To Next Page
Loading...