GEFRAN-SIEI ARTDrive Vector V2 Series - Page 267

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
ARTDrive V2 series - Instruction Manual Chapter 6 Parameter • 267


 COMM / SBI
The communication with the SBI Bus field option cards (Serial Bus Interface) is
performed via two channels:
• Synchronous or Process channel (PDC Process Data Channel) for a cyclical value
interchange.
• Asynchronous or Configuration channel for a low priority access to all the Drive
parameters.
As for the data exchange modes between the SBI card and the Network see the SBI card
documentation.
The process data exchange between the Drive and the SBI has the following structure:
> the interface is made of six writing Words and six reading Words
> the source Drive parameter has to be defined for the six Words
Drv -> SBI word transmitting the data from the Drive to the SBI. Six Words move the
data from the SBI to the Drive.
SBI -> Drv word these can be found in the source selection lists.
For more information to see the following documents for related information on SBI:
1S5E35 (GB), 1S5E48 (I) for SBIPDP33 Profibus card
1S5E57 (GB), 1S5E64 (I) for SBIDN33 DeviceNet card
M01 COMM / SBI
NOTE! Menu accessible with Access Level = FULL.
M01.00 SBI enable N/A RWS 0 0/1 DK V-F-S-B Full 8999
It allows to enable SBI Field Bus option cards:
[0] Disabled
[1] Enabled
NOTE! SAVE PARAMETERS command and drive recycle power are required.
M01.01 Last SBI error N/A R 0 0/2 DP V-F-S-B Full 8998
It defines the last found error:
0 = OK (no error)
1 = Hardware fault
2 = Bus Loss
M01.02 SBI menu Full
It allows to access SBI card parameters, when the card is connected.