GEFRAN-SIEI ARTDrive Vector V2 Series - Page 298

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 298 ARTDrive V2 series - Instruction Manual


 APPL CFG / PDcontrol
This block performs the Proportional Derivative regulation. The PD block has on the input
the PID Input value (output value of the PID Input block), which usually states an error.
The output of the block is added to the other corrections in the PID output block.
The O04.00 - PID PD enab src source allows to enable the PD function. The gains can
be adjusted according to the variable selected on the O04.01 - PDGP ref src source.
The Block allows to set a Profile on three segments.
PDGP ref src
PD P3 gain %
P
D
REF
(REF)
PDGP tran21 band
PDGP tran21 hthr
PID input
PID PD enab src
PD PD out mon
PD P gain mon
+
+
PD der filter
PD D gain mon
PDGP tran32 Ithr PDGP ref mon
PD P2 gain %
PD P1 gain %
PD P3 gain %
PD P2 gain %
PD P1 gain %
PDGP tran32 band
Figure O04: PD control block
O04 APPL CFG / PD ctrl
NOTE! Menu accessible with Access Level = FULL
O04.00 PID PD enab src N/A RWS Ipa4000 PList 3 PIN V-F-S-B Full 7340
Ipa 4000 - NULL = Default
It allows to enable the PID PD (Proportional Derivative) part.
ªª
ªª
ª
Pick List 3
O04.01 PDGP ref src N/A RWS Ipa7311 PList 37 PIN V-F-S-B Full 7310
Ipa 7311 - Int PDGP ref = Default
It allows to select the origin signal of gain adjusting, according to the variable selected on
the PDGP ref src.
ªª
ªª
ª
Pick List 37