GEFRAN-SIEI ARTDrive Vector V2 Series - Page 350

350 • Chapter 8 Appendix ARTDrive V2 series - Instruction Manual
In most cases it is enough to set a new value which is within the limits.
DB error code list
0 no error
1 SBI PROBLEM 0x01
2 Generic error
3 Attribute not exist
4 Limit High
5 Limit Low
11 Division by zero
12 Int Overflow
13 Int Undefflow
14 Long Overflow
15 Long Underflow
16 Domain Error
17 Indirection Error
18 Reached wrong eof
19 Dbase not configured
20 Value not valid
21 Process doesn’t reply
22 Wrong record size
23 Attribute read only
24 SBI PROBLEM 0x18
25 Command not yet implemented
26 Command wrong
27 Read file error
28 Header wrong
29 Reserved for internal use
30 Parameter not exist
31 Parameter read only
32 Parameter ”z” only
48 SBI PROBLEM 0x30