- 153 -
Measure left semi slide bushing ID of driven wheel.
Usage limit: 33.06mm。
15.6.1 Change right semi bearing of driven
wheel
Remove needle bearing from right semi driven wheel.
Remove elastic retaining ring and outer rolling bearing. 。
Note:
Disassembled bearing is unusable.
滚针轴承 needle bearing
滚动轴承 rolling bearing
弹性挡圈 elastic retaining ring
Grease outer rolling bearing and put it into bushing.
Note：
Press outer rolling bearing into bushing, face the marked side outward, and then fill the shaft cavity with 8-9g
grease. Install elastic retaining ring.
Install needle bearing.
Press needle bearing with the tool in the figure.
15.6.2 Assemble clutch/driven wheel
To Next Page
Loading...
