2.4 What to do With the Water Supply Line:
● Locate the supply line at the rear of the machine
● Equip the line with a shut-off valve
1. Flush the water supply line before connecting it to the machine. A minimum of 5
gallons is usually required before connecting the machine to the supply line. DO
NOT flush the machines water system. If you do, you might introduce water line
contaminants into the machine.
2. The machine should be situated within 3 feet (1 meter) of a drinking water supply.
Connect the hose supplied with the machine to the water supply ensuring that the
seal supplied is fitted correctly.
3. Connect the hose to the inlet valve located on the rear of the machine. Ensure that
the seal is correctly fitted. Ensure that all water supply fittings are tight.
4. Water Filter: Genesis B2C machines are fitted with a CoEx® brewer and must
be connected to the water supply via a water filter. This filter must be of food
grade quality and able to remove temporary hardness (scale), heavy metals (lead,
copper, iron, cadmium), chlorine and any organic pollutant's/discolouration.
Note: If the machine is connected to the water supply and used without a water
filter as specified above, the warranty will be void.
5. Turn on the water supply and check for leaks. Prime the water filter following the
instructions supplied by the filter manufacturer.
2.5 Connecting the Electricity Supply
Safety First! The power cord furnished with the machine has a 3-prong
grounded type attachment plug. It must be plugged into a 3 prong grounded
type receptacle grounded in accordance with National and Local electrical
codes and ordinances.
Important: If the power cord becomes damaged in any way it must be replaced with
one of the same type available from the manufacturer of this machine.
9
Technical Manual
To Next Page
Loading...
Need help?
General