2.6 Set-Up Procedure
1. Ensure that the electrical and water services to the machine are connected
correctly and turned on. Ensure that the waste tray is fitted correctly to the
machine. Open the front door of the machine and swing the cup turret assembly
out of the machine.
2. Soluble Ingredient Canisters: Rotate soluble ingredient canister outlets to
upright position and remove the canisters - DO NOT place ingredient canisters
on the floor. Remove the canister lids.
Fill the canisters with the correct ingredients, re-fit the lids and re-fit canisters
into machine ensuring that they are returned to their correct positions. Rotate
the canister outlets to their correct operating positions.
Fresh Beans Container: Release the clips securing the
bean container cover as shown in the photograph.
Carefully lift the cover from the container. DO NOT
place the cover on the floor.
Fill the container with fresh coffee beans. The container
has a capacity of approximately 4.0 lbs (1.8 kgs). Refit the
cover ensuring that the clips are located correctly.
Note: To maintain optimum drink quality, Crane Merchandising Systems
recommend that the bean container is replenished on a daily basis.
3. Remove the turret cap and fill the tubes with the correct
size cups for the type of cup catcher fitted to the machine.
Load the cup turret only with cups that have been
designed for use in a hot beverage vending machine.
Allow the cups to drop into the tubes directly from the
packaging. DO NOT TOUCH THE CUPS WITH YOUR
HANDS.
Important: Do not fill the tube directly above the cup dispense position. Allow
the cup turret motor to rotate a full tube to the cup dispense position. Rotating
the cup turret by hand will damage the mechanism.
Note: If paper cups are being loaded, each pack of cups must first be inspected
for damage to the cup rims. Damaged cups must not be used.
4. Swing the cup turret assembly back to its operating
position. Ensure that the unit is held securely by the
magnetic catch. Insert the safety key (a) supplied with the
machine into the door switch as shown. The machine is
now on. The water inlet valve will open and the cup turret
10
Technical Manual
To Next Page
Loading...
Need help?
General