Verify that the entered value is displayed in the status line at the bottom of the
display when Low Change Message is highlighted.
Note: The machine will still accept money with this value set, but may short
change the customer if there is insufficient coinage in the coin mechanism. Set the
Low Change Message and the Accept on Low Change values to the same figure
to eliminate any chance that the customer will be short changed.
8. Configure the Accept on Low Change Value
Note: This option is only applicable when an MDB coin mechanism is fitted and
configured from within the Coin Mechanism menu.
When the total value of the coins in the coin mechanism falls below the value set in
the Accept on Low Change menu, the machine will stop accepting coins and notes for
which it cannot return change. For example, if the engineer sets a value of $0.50, the
machine will not accept $0.50 coins if there is less than $0.50 value of coins in the coin
mechanism. To configure this value:
1. From the Monetary menu press the
▼ (down)
key to scroll down and highlight Accept on Low
Change and press the ↵ (Edit) key. Enter the
required value, e.g. press 0-0-5-0 using the drink
selection keypad to set a value of $0.50.
2. Press the ↵ (Edit) key to save the new value and return to the Monetary menu.
Verify that the entered value is displayed in the status line at the bottom of the
display when Accept on Low Change is highlighted.
9. Configure Credit For Failed Vend Option
Note: This menu is only available when an MDB coin mechanism is fitted and
configured from within the Coin Mechanism menu.
This option specifies how the machine will react when a vend fails. The engineer can
set one of two options:
(i) Hold Credit: With this option selected the customers credit is retained,
allowing them to either make an alternative selection or press the coin return.
(ii) Return Change: With this option selected the customers change is immediately
returned after a failed vend.
42
Technical Manual
To Next Page
Loading...
Need help?
General