1. From the Main Menu screen use the ▼ (down) key to
scroll through the menu until Coins In/Out is
highlighted. Press the ↵ (Edit) key to access the menu
screen which will look similar to the example shown.
2. From this screen the engineer can view the coin sets in the coin mechanism, the
number of coins in each coin stack and the total value of the coins. To eject coins
from the mechanism the engineer simply presses the relevant button on the
keypad eg pressing button 4 will eject a $0.25 coin. The count will reduce to 8
and the value to $2.00.
4.8 System Settings Menu
This menu allows the engineer to input text
information relevant to the machine and its location,
set the current time and date, change the language
displayed, configure the monetary system, set and
view DTS information, backup and restore machine
software, view the machine and I/O board software
versions installed in the machine, set temperature and
idle screen display options and input custom
messages.
Note: Serial Flash sub menu is only visible when a Serial Flash card is inserted into
plug J9A on the control board - see page 45.
1. Machine Information: This sub-menu allows the engineer to create a unique
identification for the machine and enter its location. A combination of text and
numerical data can be entered and stored via the machines keypad.
1. From the Systems Settings menu highlight
Machine Information and press the ↵ (Edit) key.
The LCD will display the screen as shown
opposite. To update/create a Machine ID press
the ↵ (Edit) key.
2. Enter a machine ID using the 0-9 drink selection keys. Press the relevant key until
the required letter/number is highlighted. To correct an input error press the 0
key once. To add a space between characters, press the 0 key twice.
36
Technical Manual
To Next Page
Loading...
Need help?
General