2. Sanitation Events Menu: This sub menu allows the engineer to select periods
when the machine will automatically rinse through the water system via the 6 timed
and 6 post vend rinse periods available. The default setting for all rinse periods is Off.
1. From the Main Menu press the
▼ (down) key until Timed Events is highlighted
then press the ↵ (Edit) key.
2. Once in the Timed Events menu press the
▼
(down) key to highlight Sanitation Events Menu
then press the ↵ (Edit) key. The LCD will display
the screen as shown.
The following example describes how the engineer can program a timed event to rinse
the water system at 07.00 am, everyday.
1. To set up the first timed rinse, press the ↵ (Edit)
key to access the 1 Timed sub menu. The LCD
will change and display the screen as shown. By
default the current State is set to Off as indicated
by the status line at the bottom of the screen.
2. Press the ↵ (Edit) key to access the State sub menu.
Using the
▼ (down) key, set the state to On
(indicated by the filled radio button). Press the ↵
(Edit) key to return to the 1 (Timed) screen. Verify
that the status line confirms the State is set to On.
3. Press the
▼ (down) key to highlight Event Type.
By default the event is set to Timed as indicated
by the text displayed in the status line at the
bottom of the screen. Therefore it is not
necessary for the engineer to enter this sub menu.
4. Press the
▼ (down) key to highlight Start Time
and press the ↵ (Edit) key. From this menu the
engineer sets the time at which the the sanitation
event will start. Using the drink selection keypad,
press the sequence 0-7-0-0 to set the time. If
necessary use the
▲ (up) or ▼ (down) key until
AM appears in the dotted box.
5. Press the ↵ (Edit) key to return to the 1 (Timed) screen. Verify that the correct
start time is displayed in the status line at the bottom of the screen.
52
Technical Manual
To Next Page
Loading...
Need help?
General