6. Press the ▼ (down) key to highlight Days Of Week and press the ↵ (Edit) key.
From this menu the engineer can set the days on
which the sanitation event will take place. To
select everyday (Monday - Sunday), press the
START key on the drink selection keypad. The
program automatically places an X in every box
indicating that each day is selected.
Note: To select individual days, scroll through the menu using the
▲ (up) or ▼
(down) keys until the required day is highlighted. Press the ↵ (Edit) key to select
the day, indicated by an X appearing in its adjacent box.
7. Press the X (Exit) key three times to return to the Timed Events Menu. Using
the sequence described above the engineer can quickly and easily set up additional
sanitation event periods for the machine.
It is also possible for the engineer to program up to six post vend sanitation events.
The following example describes how the engineer can program a post vend event to
rinse the water system 12 minutes after each vend.
1. From the Main Menu press the
▼ (down) key until Timed Events is highlighted
then press the ↵ (Edit) key. Once in the Timed
Events menu press the
▼ (down) key to highlight
Sanitation Events Menu then press the ↵ (Edit)
key. Press the
▼ (down) key until the first Post
Vend event is highlighted. The LCD will display
the screen as shown.
2. With Post Vend highlighted, press the ↵ (Edit)
key to access the 7 Post Vend sub menu. The
LCD will change and display the screen as shown.
By default the current State is set to Off as
indicated by the status line at the bottom of the
screen.
3. Press the ↵ (Edit) key to access the State sub
menu. Using the
▼ (down) key, set the state to
On (indicated by the filled radio button). Press
the ↵ (Edit) key to return to the 7 (Post Vend)
screen. Verify that the status line confirms the
State is set to On.
53
Technical Manual
To Next Page
Loading...
Need help?
General