3. Carefully unclip the wiper arm from the brewer unit
and place to one side.
Remove the filter assembly from the brewer.
Holding the filter assembly as shown, turn the green
locking ring counter-clockwise to its open position,
indicated by the two arrows.
Carefully remove the old filter unit down and out
of the CoEx® brewer unit. Discard the used filter
unit.
4. Using a 3mm allen key, remove the bolt securing the
brewer drive coupling to the input shaft. Pull the
coupling off of the shaft and place to one side.
Ensure that the captive lock nut is retained in the
drive coupling moulding.
5. Working from the front of the brewer, unscrew and
remove the three retaining screws which secure the
brewer unit together.
Carefully ease both the front and rear brewer
panels away from the central piston chamber/swing
arms assembly.
6. Holding the unit as shown in the photograph, rotate
the lower piston and cylinder assembly clockwise
and then remove it up and out of the swing
arms/filter holder assembly.
Discard the used lower piston and cylinder
assembly.
Clean all of the dismantled brewer components
thoroughly to remove all traces of waste coffee
product.
90
Technical Manual
To Next Page
Loading...
Need help?
General