56 DIGITAL VIDEO RECORDER
- To select the DVR to be controlled with the remote controller, press and
hold the DVR ID button. While holding the DVR ID button, press the
appropriate DVR ID number. For example, enter 05 for DVR ID 05, enter
43 for DVR ID 43, etc. Set the ID of IR controller as “00” to control all
DVR’s at the same time; whatever their DVR ID is.
2. System Name: Type in a unique DVR name to identify its location if you
have several DVR’s on your Network.
3. Key Tone: By default, the DVR emits a beep every time a button is
pressed. Set Key Tone to Off to turn the beeping off. Default is “ON”.
4. PB Deinterlace
y ON: Reduces image flickering but lessens picture quality.
y OFF: Better picture quality for still images but may have flicker on
moving pictures.
5. Auto Logout: You can configure the DVR to automatically log users out.
Default is “OFF”.
[OFF Æ 1 Minute Æ 3 MinuteÆ 5 MinuteÆ 10 Minutes]
6.
S.M.A.R.T. Monitor: Turn ON to display HDD information in the SMART
STATUS tab of DISK menu.
7. Key Sensitivity: The sensitivity of the front panel touch buttons can be
controlled in this setting.
8.2. Time
Make sure to set up the Date and Time prior to starting to record.
To Next Page
Loading...
