Change the operating language with the control panel OP30
From the menu Setup > System Menu > Configuration > Language & Date Units it is possible to change
the operating language.
Cold and warm start of PACS 3500
Carry out a “Cold start” if the CPU is not responding or the program does not work at all.
If a cold start is carried out without Flash Prom in holder A the RAM memory will be deleted.
If a cold start is carried out with Flash Prom in holder A a backup from the prom will be loaded into RAM.
Cold start
Use ESD equipment to avoid electrostatic damage.
Electrical components
1. Turn off the power to the cabinet;
2. Remove the “Flash Prom” in the socket “A” with a prom lifter.
3. Turn on the power.
4. Press the “Cold Start” button next to the battery on the CPU. Hold the button during power up
of the cabinet, and release it when the red LED turns off. Now the CPU is empty.
1. FlashProm
2. Light Emitting Diode (LED)
3. "Cold start" button
Page 126 of 166
<Doc_TEC><Doc_6001341502><Rel.A><Lang_en>
To Next Page
Loading...
Need help?
General
