SAFETY PRECAUTIONS
This machine has a number of built-in safety devices.
To avoid injury, it is highly important not to bypass these safety devices.
If the equipment is used in a manner not specified by the manufacturer this can impair the safety
equipment on the machine.
Operators and maintenance personnel must undergo safety training for the machine. All personnel who
handle chemicals for washing and disinfection must understand the washing process, possible health
hazards and ways of detecting leaks of toxic chemicals.
Operators and maintenance personnel must undergo regular training in the operation and maintenance of
the equipment. There must be a documented list of personnel who have been trained to use the
machine. Trained personal must be tested to verify the training program.
Important
• Take care when handling the chemical agents used in the machine. Read the instructions on
the pack or contact the manufacturer before using the machine for instructions about:
o
if the agent comes into contact with the operator’s eyes or skin or if the vapors are
breathed in, etc.
o
for storage of packs and sorting of empty packs
o
use personal safety equipment such as safety goggles, protective gloves, etc.
• The machine must be connected in accordance with the instructions given in the installation
manual.
• The machine may only be used by adults.
• Installation and servicing may only be done by personnel trained for this machine.
• Never bypass door safety switches.
• Leaks in the system caused by worn seals in the door, for example, must be repaired
immediately.
• Before any welding is done, all cables connected to the control system via connectors and
sockets must be disconnected.
• Before doing any servicing or maintenance work on the machine, isolate it from the electric
power supply and drain all tanks.
• Do not wash down or hose down the machine with water.
• Take care when using corrosive substances.
• Observe safety measures for steam and hot water.
• The machine must not be operated with cladding plates, roof and plinths removed. Doing this
puts at risk the safety and functioning of the machine.
• The electrical cabinet may only be opened by authorized and trained personnel.
• Spare parts may only be obtained from Getinge sales companies.
Isolator switch
The machine must be preceded by a lockable switch for the electric power supply. The switch must be
easily accessible on a wall close to the machine. The installation must conform to and be marked in
accordance with local regulations.
Page 6 of 166
<Doc_TEC><Doc_6001341502><Rel.A><Lang_en>
To Next Page
Loading...
Need help?
General
