FC4500-UM-251-9370 106
7 ELECTRICAL SECTION
(13) Press the [F2] (ADJ.) key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
MOVE TO ADJ. POINT
PRESS ENTER KEY!
(14) Move the tool position to the following area of printed cross mark target by using the position keys.
Printed Cross Mark Target
Move the tool position to this area.
(15) Press the [Enter] key. The plotter will detect the printed cross mark target with a sensor, and then
plotter draws the cross mark to the detected position.
Offset of Y direction
Printed Cross Mark Target
Offset of X direction
The plotter draws this cross mark
after the Printed Cross Mark was
detected.
(16) The following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
SENSOR OFFSET ADJUST
X=0.00
mm
Y=0.00mm
(17) Measure the offset of X and Y, and then input the offset value for the X and the Y direction.
Press the [F2] key to select the X value at the above menu.
Press the [F4] key to select the Y value at the above menu.
The value can be changed by using up or down arrow keys.
Input the minus value when the drawn cross mark is shifted to the plus direction.
And you can input the factory recorded values at this times.
(18) Press the [ENTER] key after adjustment values were input.
To Next Page
Loading...
