FC4500-UM-251-9370 132
7 ELECTRICAL SECTION
7.14 Adjusting the Tool 1 and the Tool 2 position
This is adjusting exchanged tool position.
When the tool was exchanged, cutting position has to be same position.
Perform this adjustment when the Main Board was replaced or the Pen Block was replaced.
Prepare the two water-based ber-tip pens and the paper.
How to adjust the Tool 1 and the Tool 2 position
(1) Turn off the power if the power is on.
(2) Set the DIP switch to adjustment mode.
1
ON
OFF
2 3 4 5 6 7 8
(3) Turn on the power.
(4) Place the paper on the writing panel.
(5) Attach the pens to the 1st pen holder and the 2nd pen station.
(6) Press the [Next Page] key until the following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
TOOL WIDTH ADJ.
PRESS ENTER KEY!!
(7) Press the [ENTER] key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
TOOL WIDTH ADJ.
X= 0.00 Y= 0.00
Each keys are corresponding to the following operations.
F2 Key: Cursor moves to the X position adjustment menu.
F4 Key: Cursor moves to the Y position adjustment menu.
Up Position Key: Increasing the adjustment value.
Down Position Key: Decreasing the adjustment value
TEST Key: Displays the drawing positioning menu for adjustment pattern.
(8) Press the [TEST] key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
SELECT PLOT POINT
PRESS ENTER KEY!
(9) Move the tool position to the blank area of paper by using the position keys.
To Next Page
Loading...
