GRAPHTEC FC 4500 Series - 8 Test Modes; 8.1 Printing a List of the Currently Selected Conditions

FC4500-UM-251-9370 133
7 ELECTRICAL SECTION
(10) Press the [ENTER] key after the tool position was moved to the blank area of paper.
Then the following adjustment pattern is drawn.
Offset of Y direction
This Cross Mark Target drawn by the Tool 1.
Adjust the values that the drawing
becomes like this pattern.
These lines are drawn by the Tool 2.
Offset of X direction
(11) The following menu is displayed after the adjustment pattern was drawn.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
TOOL WIDTH ADJ.
X= 0.00 Y= 0.00
Each keys are corresponding to the following operations.
F2 Key: Cursor moves to the X position adjustment menu.
F4 Key: Cursor moves to the Y position adjustment menu.
Up Position Key: Increasing the adjustment value.
Down Position Key: Decreasing the adjustment value
TEST Key: Displays the drawing positioning menu for adjustment pattern.
(12) Adjust the position by using the above keys. Input the minus adjustment value when the Tool 1
position is shifted to the plus direction.
(13) Press the [ENTER] key after adjustment values were input.
The following menu is displayed
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
TOOL WIDTH ADJ.
X= 0.00 Y= 0.00
(14) Press the [TEST] key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
SELECT PLOT POINT
PRESS ENTER KEY!
(15) Move the tool position to the blank area of paper by using the position keys.
(16) Press the [ENTER] key to draw the adjusted pattern.
(17) Conrm that the tool 1 and tool 2 position was adjusted correctly.
(18) Press the [Next Page] key to nish the adjustment.