GRAPHTEC FC 4500 Series - 7.14 Adjusting the Tool 1 and the Tool 2 Position

FC4500-UM-251-9370 126
7 ELECTRICAL SECTION
7.12 Adjusting the Tool Checking Position (FC4500-50 / 60 only)
Perform this adjustment when the Main Board was replaced.
Conrm the Pen Sense Rubber is put to the correct position if the Pen Sense Rubber was replaced (See
section 6.48.).
Prepare the two water-based ber-tip pens.
How to adjust the Tool Checking Position
(1) Turn off the power if the power is on.
(2) Set the DIP switch to adjustment mode.
1
ON
OFF
2 3 4 5 6 7 8
(3) Turn on the power.
(4) Press the [Next Page] key until the following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
SET CARCHK POS
PRESS ENTER KEY!!
(5) Press the [Enter] key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
X= 0 1st Y=+230
X=- 70 2nd Y=+230
Each keys are corresponding to the following operations.
F1: Cursor moves to the 1st pen of X position adjustment menu.
F2: Cursor moves to the 1st pen of Y position adjustment menu.
F3: Cursor moves to the 2nd pen of X position adjustment menu.
F4: Cursor moves to the 2nd pen of Y position adjustment menu.
Position Keys: Adjustment value and position of digit can be changed.
TEST key: Selects the 1st pen, and then it moves to the checking position for the 1st tool. And when
the TEST key pressed again, then it selects the 2nd pen, and then it moves to the checking position
for the 2nd pen.
(6) Attach the pens to the 1st pen holder and the 2nd pen station.
(7) Press the [TEST] key, it moves to the checking position with 1st pen.