GRAPHTEC FC 4500 Series - Page 133

FC4500-UM-251-9370 127
7 ELECTRICAL SECTION
(8) Conrm the position is almost center of the horizontal pen sense rubber plate and the vertical
position is inside the pen sense rubber plate as shown in the picture below.
The 1st pen moves to this area when the
TEST key was pressed.
Conrm the position is almost center of the
horizontal pen sense rubber plate and the
vertical position is inside the pen sense
rubber plate.
The 2nd pen moves to this area when the
TEST key was pressed once more.
Conrm the position is almost center of the
horizontal pen sense rubber plate and the
vertical position is inside the pen sense
rubber plate.
Pen Sense Rubber plate
(9) Adjust the position by using the function keys and the position keys if it is not positioned to the
correct position.
(10) Press the [TEST] key once more, it moves to the checking position with 2nd pen.
(11) Conrm the position is almost center of the horizontal pen sense rubber plate and the vertical
position is inside the pen sense rubber plate as shown in the picture above.
(12) Adjust the position by using the function keys and the position keys if it is not positioned to the
correct position.
(13) Press the [Enter] key to set the adjustment values after the position was adjusted.
(14) The next adjustment menu is displayed.
(15) You don’t need to perform the following steps if you want to continue to the next adjustment.
(16) Turn off the power.
(17) Set the DIP switch to the normal settings.
1
ON
OFF
2 3 4 5 6 7 8