GRAPHTEC FC 4500 Series - Pen Board

FC4500-UM-251-9370 37
6 REPLACEMENT PROCEDURES
6.20 Pen Board
How to detach the Pen Board
(1) Detach the Y Rail Cover (See section 6.3.).
(2) Detach the Pen Block Cover (See section 6.17.).
(3) Disconnect the Registration Mark Sensor Cable from the Pen Board.
(4) Disconnect the Pen Flexible Cable(s) from the Pen Board.
(5) Disconnect the Y Flexible Cable from the Pen Board.
FC4500-50 / FC4500-60
Registration Mark Sensor Cable
Pen exible Cable
Y exible Cable
Pen board
M3L6 binding head screw
FC4510-60
Registration Mark Sensor Cable
Registration Mark Sensor Cable
Pen exible Cable
Y exible Cable
Pen board
(6) Remove the two M3L6 binding head screws holding the Pen Board, and then detach the Pen Board
from the Y slider.