GRAPHTEC FC 4500 Series - 7.6 Adjusting the Pen Pressure

FC4500-UM-251-9370 91
7 ELECTRICAL SECTION
7.2 List of Readjustment Items
If you replaced one of the parts listed in the table below or altered their sensor positions, be sure to
readjust the corresponding items.
Replacement Parts
Adjustment Item
Main Board
Pen Relay
Board
X Home
Sensor
Board
Registration
Mark Sen-
sor board
Pen Block X or Y Motor X or Y Belt
Updating the Firmware M
NOVRAM Clear M
Registration Mark Sensor Level M M
Registration Mark Sensor Position M M
Pen Pressure M M
Home Position M M M M
Distance Accuracy M
Pen Exchange Position
(FC4500-50/FC4550-50/FC4500-60)
M M
Pen Sense Position
(FC4500-50/FC4550-50/FC4500-60)
M M M
Tool 1 and Tool 2 Position M M
Gain Value input M
Pen Block Height M
Registration Mark Sensor
Bracket Height
M M
Belt Tension M M
Y Bar Right Angle N
The rmware must update to the latest version unless otherwise specied.
M: Must adjust N: To be adjusted as necessary