FC4500-UM-251-9370 81
6 REPLACEMENT PROCEDURES
6.45 High Voltage board (FC4500-50 only)
How to detach the High Voltage board
(1) Detach the Corner Cover 50R (See section 6.8.).
(2) Detach the Corner Cover A (See section 6.9.).
(3) Detach the Panel R (See section 6.10.).
(4) Detach the Right Side Cover (See section 6.12.).
High Voltage board
(5) Remove the four M3L6 binding head screws holding the High Voltage board, and the detach it.
M3L6 binding head screw
High Voltage board
(6) Disconnect the writing panel cable from connecter.
(7) Disconnect the high voltage board power cable from the High Voltage board by using the soldering
iron.
Cable from the writing panel
Cable from the main board
Disconnect these cables by
using the soldering iron.
How to install the High Voltage board
(1) Reattach the High Voltage board in the reverse order in which it was detached.
To Next Page
Loading...
