GRAPHTEC FC 4500 Series - 10.4 Running a Cutting Test

FC4500-UM-251-9370 151
10 SPECIFYING THE PEN CONDITIONS
10.2 Selecting a Set of Cutting Conditions
Four different sets of user-dened cutting conditions can be registered in the plotter’s memory as COND
Nos. 1 through 4. To specify a set of cutting conditions, you must rst select the destination COND No. By
selecting a different COND No., you can easily switch between pre-dened cutting conditions for four types
of media.
Procedure
(1) Press a function key (
F1
,
F2
,
F3
, or
F4
) to select a pre-dened set of cutting conditions of the
corresponding number.
(2) The selected set of cutting conditions are loaded to the plotter and become the currently selected
cutting conditions.