FC4500-UM-251-9370 97
7 ELECTRICAL SECTION
7.6 Adjusting the Pen Pressure
Perform this adjustment when the Main Board or the Pen Block was replaced.
Input the factory recorded values if the Pen Block was not replaced.
Measure the pen pressure if the Pen Block was replaced, and then input the new values for the new Pen
Block.
Prepare the following jigs to measure the Pen Pressure if the Pen Block was replaced.
• Correx tension gauges (50 g, 300 g, 500 g)
• Cutter plunger (Adjust the blade length to the 0. The blade should be not come out from the plunger.)
How to adjust the Pen Pressure
(1) Conrm that the Pen Block is installed to the correct height (See section 6.18.).
(2) Mount the cutter plunger to the cutter holder.
(3) Turn off the power if the power is on.
(4) Set the DIP switch to adjustment mode.
1
ON
OFF
2 3 4 5 6 7 8
(5) Turn on the power.
(6) Press the [Next Page] key until the following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
PEN PRESS ADJUST
PRESS ENTER KEY!!
(7) Press the [Enter] key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
PEN PRESS ADJUST
AUTO MANUAL
(8) Press the [F4] (MANUAL) key. (At this time, do not press the [F2] (AUTO) key.)
The following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
PEN PRESS SETTING
No.1 -> 24[
g
]
To Next Page
Loading...
